| View previous topic :: View next topic |
| Author |
Message |
wong tat
Joined: 17 Sep 2005
Posts: 3
|
 Posted: Sun Feb 12, 2006 10:44 pm Post subject: Failing to apply SCXII |
 |
|
hello
i'm crying for help:
i've installed & applied SCXIIc but it couldn't be started the game any more
i.e. once it is started SubCommand, it shut down at once...
could anybody explain why & the entire installing procedures...?
thanks a lot
wong tat |
|
| Back to top |
|
 |
Ultraboy
Joined: 13 Nov 2003
Posts: 152
Location: The Mysterious Canadas
|
| Posted: Mon Feb 13, 2006 2:34 pm Post subject: |
|
|
There are a couple of .bat files you have to run before SCXIIc will work, in case you haven't already done so...
1) Go to your Sub Command\Graphics folder, there is a file called Install_Graphics.bat. Run it, it usually takes a while so be patient.
2) Go to your Sub Command\Interfaces\AkulaII folder, there is a file called Install_Loadout.bat. Run it as well.
These are the two steps I missed the first time I installed SCX, and I was having the same problem. Hope this helps! |
|
| Back to top |
|
|
Bellman
Joined: 14 Feb 2004
Posts: 1724
|
| Posted: Wed Feb 15, 2006 12:00 pm Post subject: |
|
|
Yeh as Ultraboy said - just right for SCX and if you go on to SCX2 you have to run another Install_Graphics.bat.
Might help to rename the SCX one post install (I think you can remove it ) - that ensures that subsequently
you dont rerun the old one rather than the later addition.
Happened to me. :down: |
|
| Back to top |
|
|
Bellman
Joined: 14 Feb 2004
Posts: 1724
|
| Posted: Fri Feb 17, 2006 2:47 pm Post subject: |
|
|
| Wong - did you get up and running ok ? |
|
| Back to top |
|
|
|
